Tool set up, Operating instructions, Typical appliance power consumption – Harbor Freight Tools Centech 2000watt continuous power inverter 69662 User Manual
Page 8
Page 8
For technical questions, please call 1-800-444-3353.
Item 69662
Operating instructions
Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO pRevent SeRiOuS inJuRY FROm aCCiDental OpeRatiOn:
make sure that all power Switches/triggers is in the off-position and unplug the tool
from its electrical outlet before performing any procedure in this section.
Operating instructions
1. Plug 120 V~ device(s) into the receptacles. Switch
all devices off. The devices must not use more
than the rated wattage during continuous operation,
otherwise they may overload the Inverter.
2. Turn the inverter’s Switch on.
nOte: Some rechargeable tools/appliances may
damage the Inverter or the device(s). When first
using a rechargeable device, check the Inverter’s
temperature for the first ten minutes. If it becomes
abnormally hot, do not use the device with the Inverter.
3. Turn the tool or appliance(s) on, one at a time. If
the alarm sounds, turn off the device(s). Unplug
the device(s) from the Inverter. Check the
wattage of the devices, if there were multiple
devices plugged in, discontinue use of one or
more. If a single device set the alarm off, it is
not appropriate for use with the Inverter.
4. If the inverter is powered by a vehicle’s starting
battery, be careful not to discharge the battery
to the point that it will no longer start the engine.
If needed, operate the engine periodically to
maintain the batteries charge. Do not operate
a vehicle’s engine in an enclosed space.
5. Inverter will consume some power while on, even
without loads attached. Turn inverter off after use.
typical appliance power Consumption
product
Wattage
Laptop
50
Stereo
200
Mixer
200
Table Fan
200
TV-VCR
250
Computer
250
Small Refrigerator
350
Jigsaw
350
Belt Sander
350
3/8" Drill
350
Blender
350
Laser Printer
400
Food Processor
400
product
Wattage
Reciprocating Saw
600
AC (5,000 BTU)
700
Vacuum
750
Chest Freezer
800
Coffee Maker
850
Iron
1050
Mini Microwave
1200
Hair Dryer
1200
10" Saw
1350
note: this chart is intended as a general guideline
only, actual appliance wattage requirements will
vary. Some appliances listed above may require a
pure sine wave inverter instead for proper operation.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup