haier GDE700AW - Manual (Page 21)

20
Français
RACK DRY CYCLE
1. Press any button except "Off" button to power on.
2. Press "Timed-Dry Cycles" button and select "Rack Dry" cycle.
• After powering on, press "Timed-Dry Cycle" button to select "Rack Dry"
program.
3. Press "More Time" And "Less Time" buttons to set a suitable time.
• After setting "Timed-Dry Cycle" to "Rack Dry", you can press these two
buttons to increase or decrease drying time as you desire.
4-7.Press buttons "Temp", "Signal", "Wrinkle saver", and "Touch Up" to define
your desired program.
Notes: For "Rack Dry" program, use of buttons "Temp", "Signal", "wrinkle Saver"
and "Touch up" is the same as for auto-programs. "Sensor Dry Level" is
here inactive, pressing of which will get alarms.
8. Press "Start/Pause" button.
Other Features
Your dryer also has the following features for your convenience:
Lint Filter:
• All dryers come with a lint filter that needs to be cleaned before or after every
use (read “Care and Cleaning Guide” Section).
Leveling Legs:
• Your dryer has four leveling legs which are located in the front and rear cor-
ners of your dryer. After installing your dryer in its final position, you can level
your dryer.
• Leveling legs can be adjusted by turning them clockwise to raise your dryer or
by turning them counterclockwise to lower your dryer.