haier 34F9K - Manual (Page 25)

24
Troubleshooting guide
To assist in location possible faults use help guide below .
BREAKDOWN PHENOMENON
PICTURE SOUND
CHECKING
The aerial direction and connection
Ensure that the power supply is connected to the TV
set and turned on. Also ensure that the TV set is not
in "Listen Mode" or that the brightness and contrast
are not turned down.
Adjust colour control
Adjust channel again
Colour Purity fault which can be caused by moving
the TV set, placing magnets near the TV screen or
turning on/off house hold appliances such as vacuum
cleaners near the TV set. Turn the TV off with the
mains power switch for 15 minutes. When the power
is turn on again the TV set will automatically degauss
the picture. In server cases leave the TV set turned
off over night.
Picture with snow Noise
Colour Spot Normal volume
Scramble Normal or Weak Volume
No colour Normal volume
No Picture No sound
No sound Normal
Normal
Disturb Noise
Double or Triple Image
Note:
1.If the fault can not be repaired using the above guide consult with your local authorized service
center.
2.The TV set must only be repaired by a qualified registered service person. Never attempt to
remove the back cover as the TV set has dangerous voltages in side that may cause a fatally or fire.
3. The cabinet may produce the occasional "snapping sound" This is normal and caused by the
materials in the cabinet expanding with room temperature changes.
Electrical interference which can be caused
by cars, motorbikes etc, Fluorescent lamps
and dirty insulators on overhead power
cables.
This is called ghosting which can be minimized with
an outside aerial, and good quality cable and
terminations. Altering the aerial direction can also
minimize this effect.
Volume Sound mute