beautypg.com

Maintenance and care – Hotpoint RLA175P User Manual

Page 7

background image

GB

7

Maintenance and care

Switching the appliance off

During cleaning and maintenance it is necessary to

disconnect the appliance from the electricity supply:

It is not sufficient to set the temperature adjustment knobs

on OFF (appliance off) to eliminate all electrical contact.

Cleaning the appliance

• The external and internal parts, as well as the rubber

seals may be cleaned using a sponge that has been

soaked in lukewarm water and bicarbonate of soda or

neutral soap. Do not use solvents, abrasive products,

bleach or ammonia.

• The removable accessories may be soaked in warm

water and soap or dishwashing liquid. Rinse and dry

them carefully.

• The back of the appliance may collect dust which can

be removed by delicately using the hose of a vacuum

cleaner set on medium power. The appliance must be

switched off and the plug must be pulled out before

cleaning the appliance.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic materials

which are odour free. In order to maintain an odour free

refrigerator and to prevent the formation of stains, food

must always be covered or sealed properly.

• If you want to switch the appliance off for an extended

period of time, clean the inside and leave the doors

open.

Defrosting the appliance

! Follow the instructions below.

Do not use objects with sharp or pointed edges to defrost

the appliance as these may damage the refrigeration

circuit beyond repair.

The refrigerator has an

automatic defrosting

function: water is ducted

to the back of the

appliance by a special

discharge outlet (see

diagram) where the heat

produced by the

compressor causes it to

evaporate. It is necessary

to clean the discharge

hole regularly so that the water can flow out easily.

Replacing the light bulb

To replace the light bulb in the refrigerator compartment,

pull out the plug from the electrical socket. Follow the

instructions below.

Access the light bulb by removing the cover as indicated

in the diagram.

Replace it with a similar light bulb within the power range

indicated on the cover (15W or 25W).

1

1

2