Harbor Freight Tools ONESTOP 92508 User Manual

Page 7

SKU 92508 For technical questions, please call 1-800-444-3353.

PAGE 7

OPERATION INSTRUCTIONS

Figure 3

View from underneath the Base (1).

MAINTENANCE INSTRUCTIONS

SENSITIVITY Setting

This controls the amount of motion

needed to trip the sensor and the distance
that the sensor detects motion at. Keep in
mind that the motion sensor’s range is
approximate and many different factors
can affect the range that this unit detects
motion at.

Turn the dial clockwise to increase the

sensitivity and counterclockwise to make the
unit less sensitive.

Refer to Figure 3 on the right for the

location of the different settings.

TIME Setting

This controls the amount of time that the

light stays on when the sensor is tripped.

Turn the dial clockwise for more time (up

to 5 minutes) and counterclockwise for less
time (down to one minute).

MODE Settings

TEST

This mode leaves the lantern on con-
stantly and illuminates the red light on
the control panel if the unit detects mo-
tion. This setting is helpful for adjusting
the sensitivity.

PHOTO

This mode switches the lantern on when
darkness falls.

SECURITY

This mode illuminates the lantern for the
duration set by the TIME setting when-
ever the sensor detects motion.

Shut the unit off at the wall switch before

performing any maintenance, or inspection
procedures, or before changing the light bulb.

Inspect the unit periodically. Check for
loose mounting, breakage of parts, and
any other condition that may affect the
lantern’s operation. If damaged, have the
lantern serviced before use. Many acci-
dents are caused by poorly maintained
fixtures.

Weekly, wipe the lantern and sensor off
with a damp cloth.

To Change The Bulb:
A. Shut off the switch and wait until the

lantern has cooled off.

B. Remove the Hood Nut (4) and the

Hood (3).

C. Loosen and remove both Nuts (7).
D. Remove both Washers (6) and the

Hood Bracket (5).

E. Using protective gloves, remove the

old bulb and install a new type A bulb
of 100 watts or less.

F. Reassemble the lantern securely.