Hitachi Koki USA DS 12DVF - Manual (Page 20)

English
20
Cap
Tightening torque Operation example
position
Approximately 9 in-lbs. (10 kg-cm)
Approximately 15 in-lbs. (17 kg-cm)
Approximately 23 in-lbs. (26 kg-cm)
Approximately 35 in-lbs. (40 kg-cm)
Approximately 43 in-lbs. (49 kg-cm)
Approximately 52 in-lbs. (60kg-cm)
High speed: approximately 52 in-lbs.
(60 kg-cm)(DS9DVF)
approximately 61 in-lbs.
(70 kg-cm)(DS12DVF)
approximately 70 in-lbs.
(80 kg-cm)(DS14DVF)
Low speed: approximately 156 in-lbs.
(180 kg-cm)(DS9DVF)
approximately 191 in-lbs.
(220 kg-cm)(DS12DVF)
approximately 213 in-lbs.
(245 kg-cm)(DS14DVF)
1
3
7
13
17
22
Machine screw
tightening
Screw tightening for soft
wood material
Screw tightening for
hard wood material
Thick screw tightening
When used as a drill.
THE SCOPE AND SUGGESTIONS FOR USES
Table 3
HOW TO SELECT TIGHTENING TORQUE
Table 4
NOTE:
The selected content shown in Table 4 indicates the differences according to screw type,
screw size and material used.
CAUTION:
●
While operating the Cordless driver drill, take care not to lock the motor.
If the motor is locked, immediately turn the power off.
If the motor is locked for a while, the motor or battery will be burnt.
●
Do not tighten too strongly as the screw heads will be damaged.
Work Cap position Suggestions
Wood
Drilling Steel Use for drilling purpose.
Aluminum
Screw
Machine
1 – 22
Use the bit and socket matching the screw
tightening
screw diameter.
Wood
1 – Use after drilling a pilot hole.
screw