Hafler GX2600CE - Manual (Page 23)

– 21 –
1. Connect signal from source to CH B input.
2. Stereo/Biamp switch not active (Stereo/Mono switch
overrides this switch when in mono/70V/100V mode).
3. Move Stereo/Mono switch to 100V mode.
4. Select 100V load, both channels.
5. Connect parallel array of 100V transformer-equipped
speakers across the red terminals of the 5-way binding
posts. (1200W – GX2600, 600W – GX2300)
6. CH B input sensitivity controls 100V mono output level.
Amplifier will clip at 100Vrms level.
1. Connect signal from source to both CH A and CH B inputs.
2. Move Stereo/Biamp switch to Stereo mode.
3. Move Stereo/Mono switch to Stereo mode.
4. Select 8
Ω speaker load for each channel.
5. Connect parallel array of 70V transformer-equipped
speakers (up to 600W per channel) to 5-way binding
posts.
6. Adjust CH A and CH B level controls independently.
100V MONO MODE (GX2300/GX2600)
70V STEREO MODE (GX2600 ONLY)
GX
-