Healthrider PRO H500i HRTL71706.0 - Manual (Page 8)

7. Set the console assembly on the Handrail (20).
Be careful to avoid pinching any of the wires.
Make sure that the ground wire (see step 5)
and the wire from the console assembly (see
step 6) are in the indicated channel.
Hand tighten five Screws (3) into the Handrail
(20) and the console assembly.
Do not put
Screws into the two indicated holes. Start all
five Screws, but do not tighten them yet.
6. While the second person continues to hold the
console assembly, locate the wire underneath
the console assembly.
Connect the wire from the console assembly to
the Upright Wire Harness (77).
Make sure to
connect the connectors properly (see the
inset drawing). The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again.
IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Then, insert the connectors downward into the
Handrail (20).
8
Console Assembly
3
3
No screws
3
20
77 Console
Assembly
77
20
7
5. While a second person holds the console as-
sembly near the Handrail (20), attach the ground
wire to the indicated hole in the Handrail with a
Ground Screw (33).
20
Hole
Ground
Wire
Console
Assembly
33
5
6
Wire
Channel