Harbor Freight Tools 03914 - Manual (Page 4)

Page 4 SKU 03914
17. Use proper size and type extension cord. If an extension cord is required, it must be
of the proper size and type to supply the correct current to the tool without heating up.
Otherwise, the extension cord could melt and catch fire, or cause electrical damage to
the tool. This tool requires use of an extension cord with up to 10 amps capability (up
to 50 feet), with wire size rated at 18 AWG. Longer extension cords require larger size
wire. If you are using the tool outdoors, use an extension cord rated for outdoor use.
(signified by “WA” on the jacket).
20. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
21. Pacemaker safety warning. People with pacemakers should consult with their
physician(s) before using this product; operation of equipment in close proximity to a
heart pacemaker could cause interference or failure of the pacemaker.
Note: Performance of this tool may vary depending on variations in local line voltage. Exten-
sion cord usage may also affect tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Sewing Safety Precautions
1. Keep hands away from the needle when you turn the power switch on, or while the
machine is operating.
2. Do not place your fingers into the thread take-up cover while the machine is
operating.
3. Always turn the machine off and unplug the power cord to the electrical outlet before
tilting the machine head or removing the V-belt.
4. Never leave the machine running and unattended.
5. During operation, never place your head, hair, or hands in the proximity of the hand
wheel, V-belt, bobbin winder, or motor.
6. Do not operate the machine with any safety guards removed.
Unpacking
When unpacking, check to make sure that the parts shown in the photo on the following
page are included. Note that the machine table shown is not included, and must be ordered
separately. If any parts are missing or broken, please call Harbor Freight Tools at the num-
ber on the cover of this manual as soon as possible.