Hasbro Air-tivity Ball Popper 6104 - Manual (Page 3)

T TO O IIN NS ST TA AL LL L B BA AT TT TE ER RIIE ES S
Use a Phillips screwdriver to
loosen screw in battery
compartment door (screw
remains attached to door). Slide
door to the right and remove.
Insert 4 fresh "D"/LR20 (1.5V)
alkaline batteries. Fit door onto
unit (tabs into notches), then slide
door to the left. Tighten screw.
CAUTION:
TO AVOID BATTERY LEAKAGE
1) Be sure to insert the batteries correctly and always follow
the toy and battery manufacturers' instructions;
2) Do not mix old and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3) Always remove weak or dead batteries from the product.
IMPORTANT:
BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert item correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types
of battery. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.