Harbor Freight Tools 41453 - Manual (Page 5)

SKU 41453 For technical questions, please call 1-800-444-3353. PAGE 5
7. NOTE: Performance of this tool may vary depending on variations in local line
voltage. Extension cord usage may also affect tool performance.
8. MAINTAIN A SAFE WORK ENVIRONMENT. Do not use the Cut-Off Saw in or
near damp or wet areas. Do not expose this tool to rain. Keep the work area
well lit. Make sure there is adequate surrounding workspace. Use this tool in a
well ventilated area. Do not operate this tool in the presence of flammable
liquids, gases, or dust.
9. DO NOT FORCE THE EQUIPMENT. This Cut-Off Saw will do the work better
and safer at the speed and capacity for which it was designed.
10. KEEP ALL GUARDS IN PLACE AND IN WORKING ORDER.
11. REMOVE ALL ADJUSTING WRENCHES FROM THE CUTOFF SAW BEFORE
TURNING IT ON.
12. AVOID UNINTENTIONAL STARTING. Make sure you are prepared to begin
work before turning the Power Switch “ON.”
13. ALLOW THE CUTOFF GRINDING WHEEL TO SPIN UP TO FULL SPEED
BEFORE FEEDING MATERIAL INTO IT. When turning it off, allow the Cut-Off
Grinding Wheel to spin down and stop on its own. Do not press against the
Cut-Off Grinding Wheel to stop it.
14. ALWAYS KEEP HANDS AND FINGERS AWAY FROM THE CUTOFF GRIND-
ING WHEEL. Never pass hands directly in front of, to the rear, or below the
Cut-Off Grinding Wheel when cutting a workpiece.
15. DO NOT FORCE THE CUTOFF GRINDING WHEEL INTO THE WORKPIECE
WHEN CUTTING. Apply moderate pressure, allowing the Cut-Off Grinding
Wheel to cut without being forced.
16. NEVER ATTEMPT TO REMOVE MATERIAL STUCK IN THE MOVING PARTS
OF THE CUTOFF SAW WHILE IT IS PLUGGED IN AND RUNNING.
17. TURN OFF THE CUTOFF SAW IF THE WORKPIECE IS TO BE BACKED OUT
OF AN UNCOMPLETED CUT.
18. MAKE SURE THE WORKPIECE IS FREE FROM ANY FOREIGN OBJECTS
WHICH COULD DAMAGE THE CUTOFF GRINDING WHEEL.
19. MAKE SURE THE WORKPIECE IS SUPPORTED AT ALL TIMES DURING
OPERATION. Use a Roller Stand (not provided) with a larger workpiece if neces-
sary.