haier XQB60-91BF User Manual

Page 26

English

3. Install the drain hose to the side of the washer using drain hose clamp. The drain

hose must be placed into a drainpipe or sink at least 1

1/2

inches in diameter.

Use the gooseneck to hold hose in place. To avoid possible water back up, the
drain hose must reach height of at least 31

1/2

inches minimum and 40 inches

maximum.

Note:

“Y Adaptor” shown in above figure is only for illustration. It is not provided

in the box as an accessory. If you need to utilize this type of hookup, you can
purchase a “Y Adaptor” from your nearest hardware store.

4. Plug in the Washer to a regular 115 Volt / 60 Hz, 15 Amps outlet.

Note:

Inspect carefully for any leaks around and back of the machine. If there is a
leak then double check to see if any connections are loose. You may need to
tighten loose connections.

CAUTION:

If after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer. To ensure that your Washer is
properly installed it is recommended that it be installed by a certified
installer.

Water Supply Hose

Drain Hose

Goose Neck

Water Inlet

Hose Bend

SINK

“Y” Adapter

XQB60-91BF MANUAL 10/22/01 11:42 AM Page 26