Cable assembl y – Healthrider 831.159710 User Manual

Page 9

CABLE ASSEMBL

12. Route the Long Cable (58) around a “V”-

Pulley (6).

Be sure that the Cable is in the

groove of the “V”-Pulley and that a Long
Cable Trap (50) is turned to hold the Cable
in place.

Attach the “V”-Pulley (6) and the Long Cable
Trap (50) to the Right Arm (48) with a 3/8” x 2
1/2” Bolt (7) and a 3/8” Nylon Locknut (21).
Make sure the Bolt and Nylon Locknut are
tight.

13.

Refer to the inset drawing. Using a 5/16” x
4 3/4” Bolt (64) and a 5/16” Nylon Locknut
(3), attach the Pulley Bracket (20) to the indi-
cated bracket on the Top Frame (55).

Note:

The Pulley Bracket is pre-assembled with
a 3 1/2” Pulley (15) and a Cable Trap (66).

Route the Long Cable (58) around the 3 1/2”
Pulley (15) attached to the Pulley Bracket
(20).

Be sure that the Cable is in the

groove of the Pulley and that the Cable
Trap (66) is turned to hold the Cable in
place. Make sure that the 3/8” x 2” Bolt (12),
securing the Pulley and Cable Trap to the
Pulley Bracket, is properly tightened and that
the Pulley Bracket can pivot freely.

14. Locate the Long “U”-Bracket (57) that is pre-

assembled with a 3 1/2” Pulley (15) and a
Cable Trap (not shown). Route the Long
Cable (58) around the Pulley and through the
Long “U”-Bracket.

Be sure that the Cable is

in the groove of the Pulley, that the Cable
Trap is turned to hold the Cable in place,
and that the Cable and Pulley move
smoothly.

15. Route the Long Cable (58) around a 3 1/2”

Pulley (15). Using a 3/8” x 1 3/4” Bolt (71)
and a 3/8” Nylon Locknut (21), secure the
Pulley to the indicated bracket on the Top
Frame (55).

Be sure that the Cable is in the

groove of the Pulley and that the Cable
and Pulley move smoothly.

Bracket