Harbor Freight Tools 66950 - Manual (Page 4)

SKU 66950 For technical questions, please call 1-800-444-3353. Page 4
ASSeMBLY
read the eNTIre ruLeS FOr
SAFe OperATION section at
the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO preVeNT
SerIOuS INjurY
FrOM ACCIDeNTAL
OperATION Or eLeCTrIC
SHOCk: Before assembly,
cleaning or adjustment, make
sure OFF key is pressed and
the cord is unplugged.
Note: For additional information regarding
parts listed, refer to Assembly Dia-
gram at back of manual.
33
30
29
28
Figure A
34
41
1. Using Screws (30) and Washers (31,
32), attach Lower Shaft (41) to Upper
Cross Stand (33) and Lower Cross
Stand (34). See Figure A, above.
Unthread and remove Height Adjust- 2.
ment Knob (28) from Lower Shaft.
Slide Base Cover (29) down Shaft
until it covers intersection of Upper
and Lower Cross Stands.
Extend Upper Column (42) from 3.
Lower Shaft and thread Height Ad-
justment Knob back onto Lower
Column until its threaded back into
place. WArNING! This must be done
before top half of Fan is assembled
onto Upper Column.
Unthread Spinner (3) from Spindle
4.
(7) by turning it clockwise. Remove
Plastic Nut (5) from Motor Housing,
by turning it counterclockwise. See
Figure B, below.
3 5
7
6
2
Figure B
42
41
23, 25
24
4
5. Slide Rear Grill (6) over retainer on
face of Motor Housing, aligning loca-
tor pin on Housing with pin hole for
Rear Grill. In this mode, the catch
on edge of Rear Grill will be at low-
est position. Thread on Plastic Nut
(5) clockwise, but do not overtighten.
See Figure B.
Insert Propeller over Spindle. Align 6.
cross-pin of Spindle with recess in
the inner face of Propeller. Attach
Spinner (3), turning it counterclock-
wise to tighten. See Figure B.
Fasten Front Grill (2) onto Rear Grill 7.
(6) using latches along edges of both
Grills and the locking screw on the