Hobart Welding Products HWC-115A - Manual (Page 6)

OM-185 480 Page 4
SECTION 2 – INSTALLATION
2-1. Typical Process Connections
Use gun Owner’s Manual when making connections. NOTE
Constant current and/or
constant voltage transformer
and engine-driven DC power
sources. If the power source
does not have a weld output
contactor, the optional
contactor kit should be
ordered.
115 Volt
Control
30 ft (9 m) Control Cord
30 ft (9 m) Weld Power Cable
40 ft (12 m) Gas Hose
Weld Power Cable (Not Included)
10 ft (3 m) 115 VAC Power Cord
10 ft (3 m) Contactor Cord
Work
Voltage Sensing Lead For CC Mode
2-2. Gun/Feeder Connections
Ref. ST-149 966-C / Ref. ST-149 549-B / Ref. S-0621-C
1 Gun Control Receptacle
2 Weld Power Grommet
3 Regulator/Flowmeter
4 Gas Fitting
Tools Needed:
5/8, 3/4 in
Left Side
Wrapper Off
1
4
2
2
3