Hotpoint WD64 - Manual (Page 10)

Is your water pressure too
high?
If the appliance is still not working
contact:
Repair Service and Information Desk
UK 08709 066 066
Republic of Ireland 1850302 200
You will be asked for the following
details: Name and Address, Post
Code,Telephone Number, Date of
Purchase, Colour and Model/Serial
Numbers - which can be found on
the inside of the door.
Clear and precise details of the query
or fault.
Did you know that putting one or two
highly absorbent items in your machine
can cause it to become
‘OUT OF BALANCE’.
This happens because the items are
clumping together, retaining large
amounts of water and therefore acting
as a heavy weight in your machine.
When your machine is ‘out of balance’ it
will not spin.
Try adding a large item such as a
bedding sheet into the load. This will
not absorb as much water and will help
to spread the weight in the drum.
allation
s that have
d
Is the standpipe or household
drain blocked.
Check the feet have been
levelled.
Is steam coming from the
dispenser drawer?
Are the fill hoses on correctly?
If not tighten them.
OES NOT
ATER
MY MACHINE IS LEAKING
THE PROGRAMME TAKES A
LONG TIME
SUDS ARE COMING FROM
THE DISPENSER DRAWER
THE LAUNDRY IS NOT DRY
AFTER USING THE DRY
PROGRAMME
nnected to
stem?
end of the
e unit has
ff.
The machine is designed to
release steam from the dispenser
drawer during hot washes.
n selected?
til the button
gain.
ld’ button
You may need to call in a
plumber.
✓
✓
Turn the main supply tap
down.
t, standpipe
ections free
ges?
een installed
?
Was the laundry spun dry at the
end of a wash programme, if not
select a spin and dry option to
suit the fabric type.
Did you select the right heat/time
setting?
✓
Is the cold water turned on at the
tap?
✓
ser drawer.
Dispenser
Check for low temperature and
low pressure for the hot and
cold water supply
Check the correct amount of
suitable detergent has been
used, refer to manufacturer’s
recommendations.
TS IN THE
ENSER
ENT
OUT OF BALANCE!
✗
✗
✗
✗
✗
✗
✗
✗
✓
eshooting