Harbor Freight Tools SOLAR LIGHT SET 97294 - Manual (Page 3)

Page 3 SKU 97294 For technical questions, please call 1-800-444-3353.
SpeciFicationS
Battery
One Ni-Cd, AA 1.2V, 600mAh
per Light (included)
unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please call
Harbor Freight Tools at the number shown
on the cover of this manual as soon as
possible.
initial Set up
inStructionS
read all warning sections at the
beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Open the battery cover on the bottom
of the unit to verify that battery
polarity is correct. Be careful not to
pull on the wires connected to the
cover, damaging the wires will render
the unit dysfunctional. If necessary,
remove tabs between the battery and
the post. The battery must make
contact with the post to operate.
Take an Inner Cover (2), place it over
the light bulb and rotate it clockwise
until the tabs on the Inner Cover are
underneath the lip on the Cap.
Turn the Solar Light on.
1.
2.
3.
Place an Outer Cover (3) over the
Inner Cover and rotate it clockwise
until the Tabs on the Outer Cover are
underneath the lip on the Cap.
Examine the area where the Solar
Light is to be placed. Make sure
there are no utility lines beneath the
surface that might be damaged. For
best results, the Lights should be
placed in an area that receives at
least eight hours of direct sunlight per
day.
lip where
tab secures
for inner
cover (2)
lip where tab
secures for
outer cover (3)
on/off Switch
battery compart-
ment cover
Place a Spike (6) onto a Shaft (4) and
push the unit firmly into the ground.
The Solar Light can either be placed
on the Shaft now, or a Connector (5)
can be used to connect another Shaft
and raise the height of the Light.
Repeat these steps to assemble all
the lights.
4.
5.
6.
7.
8.