beautypg.com

Operation, Filter run-time counters, Electrical cord storage (selected models only) – Hunter Fan 30185 User Manual

Page 11

background image

11

41451-01

Operation

Filter Run-Time Counters

The pre-filter and filter are critical to the proper operation of the air purifier. To help you
know when to change the filters, your Hunter Air Purifier has Filter Run-Time Counters that
will monitor the number of hours your filters have been in use. Although the exact life of the
filters depends on the environment, the table below gives typical usage times of the filters.

Table 2: Typical Usage Times of the Filters

To check the run-hours for each filter:

1. Press the DISPLAY key to toggle among the 3 display modes – Clock, Pre-Filter,

and Filter. The Filter or Pre-Filter indicator will illuminate when the run hours
for that filter are displayed.

2. The display shows the number of run hours since the counter was reset.

Although the maximum display value is 9,999 hours, the counters can go indefinitely. To
indicate that the counter is over 9,999 hours, the display will flash. For example, a run time
of 12,000 hours is represented by a flashing 2,000 hours.

The values of the Pre-Filter and Filter Counters are stored in the air purifier’s memory.
The unit may be unplugged and moved without losing the pre-filter and filter counter
values.

To properly track filter usage, the Pre-Filter and Filter Counters should be reset each time
the filters are changed. Refer to Changing the Pre-Filter (pg. 18) or Changing the Filter (pg.
19) for instructions on how to reset the counters.

Electrical Cord Storage (Selected Models Only)

For your convenience, some models have cord wrap posts for easy storage of the electrical
cord. The cord wrap posts are located on the back of the air purifier in the bottom corners.

When received, the cord wrap posts will be in the collapsed position. To extend the cord
wrap posts, simply twist approximately 1/8 of a rotation and gently pull outward. The post
will extend approximately 0.5 inches (see Fig. 18).
Once extended, simply wrap the cord around the two
posts until the desired length is obtained.

Filter Type

Typical Usage

Activated Carbon Pre-Filter

2000 hours

HEPA Filter

8000 hours

DISPLA

Y

Fig. 18 - Extended Cord Wrap Posts

41451-01_Rev 8-6-04.pmd

8/5/04, 5:05 PM

11

This manual is related to the following products: