Symbology, Unpacking, Pipe connection – Harbor Freight Tools Pacific Hydrostar Portable Sprinkler Pump 6842 User Manual
Page 4
Page 4
For technical questions, please call 1-800-444-3353.
SKU 68421
Symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
v~
Volts Alternating Current
a
Amperes
n0 xxxx/min.
No Load Revolutions per Minute (RPM)
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before set-up and/
or use.
WARNING marking concerning Risk of
Hearing Loss.
Wear hearing protection.
WARNING marking concerning Risk
of Fire.
Do not cover ventilation ducts.
Keep flammable objects away.
WARNING marking concerning Risk of
Electric Shock.
Properly connect power cord to
appropriate outlet.
Specifications
Power Requirements
120 V~ / 60 Hz / 11.1 A
Maximum Flow
1150 GPH
Maximum Lift
154 FT.
Pressure
67 PSI
Motor
1-1/5 Horsepower Electric
Inlet and Outlet Diameter
1 IN. NPT
Cord Length
5 FT. 2 IN.
236418
JtS-441
unpacking
When unpacking, make sure that the item is intact
and undamaged. If any parts are missing or broken,
please call Harbor Freight Tools at 1-800-444-3353 as
soon as possible.
Set up
WaRnInG! This is NOT a submersible pump.
Do not immerse in water.
Pipe connection
The Pump uses 1" NPT piping (sold separately).
Purchase the necessary length of pipe, including any
needed fittings and bends. Mount the Pump as close to
the source of water as possible and within the range of
the rated Suction Lift. The connections must be airtight.
Wrap all threaded connections with PTFE tape (sold
separately).
1.
outlet
Priming
Plug
(23)
Inlet
cover (25)
Pump body (22)
Remove the Inlet and Outlet covers (25) from the
Pump.
2.
Attach the water source to the Inlet, using
appropriate methods. The Inlet hose or pipe must
be collapse-proof to properly withstand the suction
force.
3.
Install a foot valve and filter (sold separately) at the
bottom of the inlet.
4.
Attach the outlet connection to the Outlet. A
Y-fitting with dual valves (sold separately) is helpful
for priming the pump (see next section).