HoMedics Ultrasonic Cool Mist Humidifier with Built-In soundSpa HJM-PED1 - Manual (Page 6)

10 11
Installing Instructions
1. Remove demineralization cartridge from packaging and
let it soak in water for 10 minutes.
2. Remove the tank from humidifier base. (Fig. 3)
3.
Place 1 demineralization cartridge down into left
side matching slot in the humidifier base. (Fig 9)
4. Place the tank back on the base, making sure the tank is
firmly seated. (Fig. 7)
Cleaning and Care
CAUTION: Before cleaning the unit, turn power off and
unplug unit from the outlet.
Tank Cleaning
Remove the water tank from the humidifier base by
lifting it by the handle from the main unit. Unscrew
the tank cap; wipe the tank with a soft cloth then
rinse it with clean water. (Fig. 10)
Suggestion: Clean the water tank once every two to
three weeks, depending on your water conditions.
Ultrasonic Nebulizer Cleaning
Put small amount of mild dish soap on the surface
of the ultrasonic nebulizer, then pour in some water
and soak for 5 minutes. Brush clean with soft bristle
brush (not included) and rinse. (Fig. 11)
Surface Cleaning
Clean the surface of the unit with a clean damp
soft cloth. (Fig. 12)
Fig.10
Fig.12
Fig.11
PROBLEM POSSIBLE CAUSE SOLUTION
Power Light is off • Unit is not plugged in
• No power at unit
• Plug unit in
• Press the POWER button
to turn the power on
• Check circuits, fuses, try a
different outlet
SoundSpa will not
turn on
• Unit is not plugged in
• Volume is down too low
• No sound selection has
been made
• Sleep Mode cycle is over
• Plug unit in
• Turn the SOUNDSPA
POWER/VOLUME knob
clockwise to increase
volume
• Press a sound selection
button to choose a sound
• Use the SOUNDSPA
POWER/VOLUME knob to
turn the SoundSpa OFF,
then back ON again.
Peculiar Odor • If new unit
• If unit is in use, the odor
may be a dirty tank or old
tank water
• Open the water tank cap
and keep it in a shady and
cool place for 12 hours
• Empty the old water,
clean the tank and fill
with clean water
Excessive Noise • Unit is not level
• Low water level
• Place unit on a flat,
even surface
• Check the water level. Refill
the tank if the water is low
White Dust Accumulation • Hard water used
• Demineralization Cartridge
needs replacement
• Use distilled water and a
Demineralization Cartridge
• Replace Demineralization
Cartridge
Troubleshooting
Fig. 8
Fig. 9