Harbor Freight Tools 96291 - Manual (Page 3)

Page 3 SKU 96291 for technical questions, please call 1-800-444-3353.
store idle equipment out of reach of children and other untrained persons. 6.
Tools are dangerous in the hands of untrained users.
check for breakage of parts and any other condition that may affect the oooga 7.
horn’s operation. If damaged, have the tool serviced before using.
service must be performed only by qualified repair personnel. 8. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
Maintain labels and nameplates on the oooga horn. 9. These carry important infor-
mation. If unreadable or missing, contact Harbor Freight Tools for a replacement.
warning: the brass components of this product contain lead, a chemical 10.
known to the state of california to cause birth defects (or other reproductive
harm). (California Health & Safety code § 25249.5, et seq.)
exposure to noise levels over 85 db is hazardous to hearing. 11. Always wear
ANSI approved hearing protection when operating the Oooga Horn. Never use
Horn in close proximity to people or animals, as the decibel level may cause hear-
ing damage.
before using the oooga horn, check and comply with local standards for 12.
noise pollution levels.
unpacking
when unpacking, check to make sure that the item is intact and undamaged. 1.
If any parts are missing or broken, please call Harbor Freight Tools at the number
shown on the cover of this manual as soon as possible.
asseMbly instructions
caution: Installation should be completed by a qualified technician.
Before attempting installation of the Oooga Horn, turn off the ignition, shift the gear 1.
into park (for automatic transmissions) or reverse (for manual). Remove the car
keys from the ignition switch and allow the engine to cool. Place wheel chocks on
both sides of at least 2 wheels. Disconnect the vehicle’s battery. Make sure the
engine and engine compartment are cool before beginning work.
Lift the vehicle hood and find a suitable location to mount the Oooga Horn (1). This 2.
location must shelter the Oooga Horn and Compressor from incoming rain, road
water, and mud splash from under the vehicle. Do not mount the Horn near hot
engine components or where it may come into direct contact with hot surfaces or
any moving parts.
Mount the Oooga Horn to the vehicle’s chassis using the Nut and Bolt (2). The Oooga 3.
Horn (1) should be pointing forward and slightly down for maximum efficiency. A