Hamilton Beach 840154600 - Manual (Page 4)

WARNING
Cut Hazard
How to Operate
1. Make sure the unit is unplugged.
Place base on clean, dry surface.
2. Hook front housing onto base.
3. Place ice shaving chamber in front
housing and
ensure it is
seated on the
shaft.
4. Twist shaft in direction of arrow to
lock into
position.
5. Place mixing paddle in bowl.
6. If mixing shaved ice with other
ingredients, place ingredients in
bowl.
NOTE: Use serving size markings on
bowl as a guide for appropriate ice
and liquid levels.
7. Slide bowl into place on base and
turn clockwise
until it stops at
post. This will
allow the mix-
ing paddle to
mix ice and
ingredients
once opera-
tion begins.
NOTE: The cup guide on base may
be used to shave ice into bowl or
cup other than bowl supplied.
8. Turn selector knob to desired set-
ting. Slushie setting produces finer
ice. Snow Cone setting produces
coarser ice.
9. Place ice in ice shaving chamber.
Do not fill above top rim of ice
shaving chamber.
10. Plug cord into outlet.
11. Place lid on front housing and turn
clockwise to
lock interlock
switch
(Power Start/
Stop). The
unit will start
and begin to
shave ice.
NOTE: It may be necessary to open
lid occasionally to redistribute ice.
4
• Avoid contact with shaving blade.
• Do not use if shaving blade is loose,
cracked, bent or damaged.
12. Turn lid counterclockwise to stop.
DO NOT shave ice above top ICE
line.
13. To remove bowl, turn counter-
clockwise, slide out and serve
Icy Treat.
840154600 ENv06.qxd 10/26/06 11:37 AM Page 4