Henny Penny BCF-24/65/110 - Manual (Page 7)

Model BCF-24/65/110, BCM-110
3-4. DE-ICING Henny Penny recommends performing the de-icing process after
every 3 cycles and at the end of each day. This eliminates any
ice that may have formed around the evaporator during the Chilling
or Freezing Cycles. Failure to follow this procedure increases the
time it takes to cool the product and may lead to unsafe product.
1. Remove all product from the unit.
2. Open the door.
3. Press to turn the unit on.
4. Press . The digital display now shows d. 01 . The
compressor will not come on, but the evaporator fan comes on
and pulls warm air created by the de-icing elements, across the
evaporator.
5. Allow the De-ice Cycle to run for a minimum of 10 minutes
and a maximum of 25 minutes. The unit automatically turns off
when the evaporator has been de-iced, and reaches a tempera-
ture of 77ºF (25ºC).
If the above procedures does not remove all the ice from
the evaporator, the length of time, and the temperature at
which the De-ice Cycle turns the unit off can be adjusted.
See the Programming Section.
907 3-7