haier GWT700AW - Manual (Page 12)

English
11
Washer is making noise:
• Washer may need to be reinstalled. (Check washer installation section.)
• Washer load may need to be re-balanced, as the load may be uneven.
• Coins, loose change, buttons or other heavy objects could make noise (read
Operation Guide – Normal Operating Sounds.)
• Squealing Sounds: Due to overloaded wash tub.
• Vibration Noises: Due to not leveling washer properly on the floor and uneven
distribution of clothes in the tub.
Problems with clothes:
• Clothes are too wrinkled: this is due to improper sorting, overloading and
washing in too hot water repeatedly. Avoid overloading and resort your load.
Do not mix heavy clothes such as work clothes with light clothes such as blous-
es, light shirts and delicate items. You may need to wash in warm or cold
water.
• Have soap residue: detergent may not be dissolving in water. Check water
temperature or you need to add detergent as wash tub is being filled with
water before you load your clothes to avoid soap residue on clothes.
• Spots or stains on your clothes: this is due to incorrect use of fabric softener.
You many need to read proper instructions on the container and follow proper
directions for using the softener.
• Clothes are grayed or yellowed: this is due to not pouring enough detergent
for large loads. you may have to add more detergent to the load.
• Clothes are ripped and have holes/excessive wear and tear: this is due to
sharp objects such as pins and belt buckles left in pockets. You will need to
remove small loose sharp objects. Fasten belts, zippers, metal snaps etc.
Check if you are using undiluted bleach. never add undiluted bleach to wash.
Notes:
Trouble Codes
Reason
E0 Top lid not closed during delay start sequence
E1 Blockage of drain hose.
E2 Top lid not closed during wash operation
E3 The washer is out of balance
E4 Water inlet valve closed
The water pressure is too low
E5 The water level sensor fault - Call service
E7 The communication fault - Call service