Hotpoint WMA11 - Manual (Page 15)

WARNINGS:
● Do not allow
children to
play with the
machine or
tamper with
the controls.
● If you cancel a
programme
part way
through a
wash or there
is a power
cut, take care
when
opening the
door. The
machine may
contain hot
water.
● In the unlikely
event of
something
not working
see the
Trouble -
shooting
section.
Programme
End Light
Programme
Active Light
Door Lock
Indicator Light
OFF position
Wash programmes
PR
OGR
AMMES
AND OPTIONS
15
On-Off / Selecting a programme
The machine is switched on, by turning the programme
selector dial away from the ‘OFF’ position, to your selected
programme. To start the programme press and release the
‘START/Hold To Reset’ button.
When the programme has finished return the programme
selector dial to the ‘OFF’ position.
To pause a programme
To pause a programme hold the ‘START/Hold To Reset’
button for two seconds until the ‘Prog End’ indicator light
flashes. To continue press the ‘START/Hold To Reset’ button
once more.
To change a programme
If you want to change a programme, hold the ‘START/Hold
To Reset’ button for two seconds until the ‘Prog End’
indicator light flashes. You can then change the programme.
Press the ‘START/Hold To Reset’ button to continue.
If you turn the programme selector dial during a programme
the ‘Active’ indicator light will flash to show that the
programme running is not that shown on the dial. Turn the
dial to the original programme to stop the flashing. The
flashing will stop automatically when the programme enters
the rinse phase.
‘START/Hold To Reset’
button Programme
selector dial