Harbor Freight Tools 91090 - Manual (Page 3)

SKU 91090-91091 Page 3
8. Use eye and ear protection. Always wear ANSI approved impact safety
goggles during assembly. Wear a full face shield if you are producing wood
chips. Wear an ANSI approved dust mask or respirator when working around
wood, and chemical dusts and mists.
9. Take caution as some woods contain preservatives such as copper
chromium arsenate (CCA) which can be toxic. When cutting these
materials extra care should be taken to avoid inhalation and minimize skin
contact.
10. Check for damaged parts. Before using this chair, any part that appears
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Any part that is damaged should be properly
repaired or replaced.
11. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use
accessories intended for use with this item. Approved accessories are
available from Harbor Freight Tools.
12. Do not assemble this chair if under the influence of alcohol or drugs.
Read warning labels on prescriptions to determine if your judgment or reflexes
are impaired while taking drugs. If there is any doubt, do not proceed with
assembly.
13. Maintenance. For your safety, service and maintenance should be performed
regularly. Check the alignment of all parts, and check the tightness of all
fasteners.
Warning: The warnings, cautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations
that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this product,
but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the following parts are included.
1 Back 1 Front Support
1 Seat 14 Wood Screws
2 Front Legs 10 55mm Bolts with nut and washer
2 Back Supports 2 65mm Bolts with nut and washer
2 Arms 1 Owner’s Manual
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual, or contact your local Harbor Freight retailer.