Hitachi VT-MX4530A - Manual (Page 28)

SPECIAL PLAYBACK
• Use the remote control for the following procedure.
• Be sure to check that the "PWR." and the "VCR" indicators are both on.
• Turn on the TV and set the TV channel to 3 or 4. Now set the CH3/CH4 switch on the back of the VCR to match the
channel selected on the TV.
.
AUTO REPEAT PLAYBACK
The VCR has the auto repeat function that allows you to repeat a tape indefinitely without touching the PLAY button.
Make sure to insert a prerecorded tape.
1 Select main menu
Press MENU button until the main menu appears.
MENU
TIMER PROGRAMMING
→
AUTO REPEAT [OFF]
PICTURE SELECT
CHANNEL SET UP
CLOCK SET
LANGUAGE SELECT
2 Select "AUTO REPEAT"
Press the PLAY/ or STOP/ button to point to "AUTO REPEAT".
3 Begin Auto repeat playback
Press the F.FWD/ button so that [ON] will appear next to "AUTO REPEAT" on the TV screen.
When in Stop mode, Repeat playback mode will start automatically.
If the on-screen menu still remains, press the RESET/EXIT button to exit the menu.
• Once you select the Auto Repeat mode, it stays in effect even after you turn off the VCR.
• The COUNTER MEMORY button does not function if the Auto Repeat mode is set to [ON]. In this case, set the Auto
Repeat mode to [OFF].
• To stop playback, press the STOP button.
TO EXIT THE AUTO REPEAT MODE
Repeat steps [1 ] to [2], Then, press the F.FWD/ button. [OFF] will then appear on the menu. Then, press the
RESET/EXIT button to return to TV mode
Power failure: If there is a power failure for more than 30 seconds, Auto Repeat Playback will go to off.
PICTURE SELECT
This function enables you to select the picture quality of a tape.
• This selection must be done during playback.
1 Insert a tape into VCR
Begin playback.
2 Select main menu
Press the MENU button until the main menu appears.
MENU
TIMER PROGRAMMING
AUTO REPEAT [OFF]
→
PICTURE SELECT
CHANNEL SET UP
CLOCK SET
LANGUAGE SELECT
3 Select "PICTURE SELECT"
Press the PLAY/ or STOP/ button to point to "PICTURE SELECT".
4 Select your desired mode
Press the F.FWD/ button until your desired mode (NORMAL, SOFT or SHARP) appears on the TV screen..
• Once you select the Picture Select mode, it stays in effect even after you turn off the VCR.
• To stop playback, press the STOP button.
Power failure: If there is a power failure for more than 30 seconds, Picture Select will go to NORMAL.