HTC 968 999732 - Manual (Page 8)

8
ASSEMBLY
1
BAGGER SUPPORT ASSEMBLY
1. Remove the four carriage bolts indicated from the
rear guard.
2. Install the bagger mount tube from the mount kit.
3. Remove the front carriage bolts securing the top
mount straps to the frame.
Remove
Kit Mount Strap
Nut
Hex Bolt
Mount Tube
4. Install kit mount straps between the mount tube
and frame as shown in the illustration. The front
side of the kit mount straps should be on the inside
of the mower frame.
NOTE: Models with vertically mounted muffler will
not use the right mount strap.
3. Tighten all hardware.
Nut
Flat Washers
Hex Bolts
Kit Mount
Strap