Honeywell FocusBT AP-010-BT - Manual (Page 11)

7
E
STABLISHING
C
OMMUNICATION
Between the Scanner and the Access Point Device
To establish communication between the scanner and access point device:
1. Connect the access point device to the host system (see pages 5 - 6).
2. Scan the address bar code on the access point device to establish a
communication connection between the scanner and the access point
device.
Figure 10. Address Bar Code
3. If successful, the scanner will respond with two beeps and the LED's on
both the scanner and access point device will stop flashing.
Important Note:
The communication link between the scanner and the
access point device is determined by the last address
code scanned.