Husqvarna 540200800 - Manual (Page 10)

10
Assembly Instructions (continued)
4. Attaching the Engine Mount and Vacuum Assembly
Tools Required:
1. Ratchet
2. 1/2” Socket
3. 1/2" Wrench
4. 9/16” Wrench
5. 9/16” Socket
6. 7/16” Socket
7. Socket Extension
1. Slide the Engine Mount into the Frame as shown.
2. Place the Vacuum Assembly on the Engine Mount and secure it tightly with four (4) 5/16” x 1-1/2”
hex bolts and four (4) 5/16” nylon lock nuts.
3. Slide the Engine Mount into the Frame so that the Vacuum Assembly is as close to the Frame as
as possible.
4. Adjust the Engine Mount to the nearest aligning holes between the Frame and the Engine Mount.
5. Secure the Engine Mount to the Frame with two (2) 3/8” x 2-1/2” hex bolts, two (2) 3/8” hex nylon
lock nuts, and four (4) 3/8” flat washers.
6. Place the Inlet Cover on the Vacuum Assembly with the inlet cylinder pointing downward and
forward toward the mower deck.
7. Secure the Inlet Cover with six (6) 1/4” flat washers and six (6) 1/4” nylon lock nuts.
Operators Guide
Engine Mount
Frame
Vacuum
Assembly
Inlet
Cover
NOTE: Auxiliary Engine kits contain a remote throttle cable that is not used with the Z2-7.