Set-up 58 – HONDA HRC216HXA User Manual

Page 60

Text mode
Original mode

SET-UP

7. From the grass bag

side of the handle,
insert the stud on
the end of the
handle support plate
through the handle
support hanger.
Make sure the stud
goes through both
holes in the handle
support hanger.

8. Install an 8 mm

self-locking nut on
the stud.

9. Tighten the locknut

on the stud at each
end of the handle
support plate.

10. Repeat Steps 5

through 9 to install
the handle support
on the other side of
the lawn mower.
Lock Nut Torque:
15 ft-lb (21 N•m)

11. Position cable ties at

the locations shown.

LEFT HANDLE

RIGHT HANDLE

HANDLE
SUPPORT
HANGER (2)

HANDLE SUPPORT
PLATE (2)

8 MM LOCK
NUT

LEFT HANDLE

HANDLE
SUPPORT
HANGER

HANDLE
SUPPORT
PLATE

STUD

CABLE
TIES

10 in (250 mm)

3 in (75 mm)

12 in (300 mm)