Hayter Mowers Power Trim 401C001001 - Manual (Page 10)

ASSEMBLY
10
F-050202L
ENGINE PREPARATION
Note: Engine does not contain OIL or
PETROL.
WARNING: Follow the engine
manufacturer’s instructions for
the type of petrol and oil to use.
Always use a safety petrol container. Do
not smoke when adding petrol to the en-
gine. When inside an enclosure, do not
fill with petrol. Before you add petrol,
stop the engine. Let the engine cool for
several minutes.
See the engine manufacturer’s instructions
for the type of petrol and oil to use. Before
you use the unit, read the information on
safety, operation, maintenance, and storage.
Note: Actual sustained horsepower will
likely be lower due to operating limita-
tions and environmental factors.
Fill Crankcase With Oil
1. Remove the oil fill cap/dipstick shown in
Figure 4. Fill the crankcase to the FULL
line on oil fill cap/dipstick. DO NOT OVER-
FILL.
2. Install the oil fill cap/dipstick and tighten
securely.
Fill Fuel Tank With Petrol
See the engine manufacturer’s instructions for
the type of petrol to use.
ОООО
ОООО
ОООО ООО
ООО
Figure 4
Fuel Cap
Oil Fill
Cap/Dipstick
n
CHECKLIST
For the best performance and satisfaction
from this quality product, please review the fol-
lowing checklist before you operate the ma-
chine:
n
All assembly instructions have been
completed.
n Check carton. Make sure no loose parts
remain in the carton.
As you learn how to use the machine, pay ex-
tra attention to the following important items:
nn Engine oil is at correct level.
nn Fuel tank is filled with fresh, clean, reg-
ular unleaded petrol.
nn Become familiar and understand the
function of all controls. Before your start
the engine, operate all controls.