haier HTF27R11 - Manual (Page 10)

9
English
Connecting to VCR:
This connection allows you to watch local channels and video programs, play or
record on the VCR while watching TV. You can also record from one channel while
watching another channel.
For normal hook up, you will need the following.
• One coaxial cable
• One pair of audio cables
• One video cable
• An S-video cable is usually included with an S-VHS VCR. If it is not included then
you may have to purchase it from local electronics retail store.
Note: If you have a mono VCR, connect one single audio cable to VCR audio out.
If you have stereo VCR with S-Video output, use S-Video cable instead of a
regular video cable. This type of connection delivers a better picture
compared to a standard VHS VCR. Do not connect a regular video cable
and S-Video cable to Video 1 or (Video 2) at the same time because it will
distort the picture.
Follow the steps below to hook up the VCR.
1) Hook up one pair of audio cables to the TV input and VCR output.
2) Hook up one video cable to the TV input and VCR output.
3) Connect coaxial cable wire to TV antenna on back of the TV and to “Out to TV”
on back of the VCR.
4) Connect coaxial cable wire that is coming out from cable box or antenna to “In
from ANT” on back of the VCR.
(When recording a program from TV, refer to your VCR’s instructions.)
ANT
L R VIDEO
AV - IN
S - VHS
AV - OUT
AUDIO
Stereo VCR
From Cable, or Antenna
L R
IN
OUT CH3
CH4
IN from ANTOut to TV
VIDEO AUDIO
Back of TV