Utilities, To add a test code i.d. prefix to all symbologies, Show software revision – Honeywell 3800gPDF User Manual
Page 109: Show data format, Resetting the standard product defaults, Chapter 9 - utilities

3800g/3800gHD/3800gPDF User’s Guide
9 - 1
9
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, included in the
) for the single character code that identifies each symbology.)
This action first clears all current prefixes, then programs a Code I.D. prefix for
all symbologies. This is a temporary setting that will be removed when the unit
is power cycled.
Show Software Revision
Scan the bar code below to output the current software revision, unit serial num-
ber, and other product information.
Show Data Format
Scan the bar code below to show current data format settings.
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your imager, or you’ve
changed some options and want the standard product default settings restored,
scan the
Standard Product Default Settings bar code below.
starting on
lists the standard product default
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).
Add Code I.D. Prefix to
All Symbologies (Temporary)
Show Revision
Data Format Settings
Standard Product Default Settings