Husqvarna HUV 5420 DXR - Manual (Page 38)

Engine Oil
26
Figure 19 Remove Engine Oil Filter
27
Figure 20 Coat Rubber Seal
4. Use a clean, lint-free rag to wipe the oil filter port flange surface clean where the oil filter gasket seats.
5. To help seal the new oil filter to the oil port flange, apply a light coat of white lithium NLGI Number 2 grease (Dow
Corning
® BR2-Plus or equivalent) or new engine oil to the rubber seal around the outside surface of the filter
before attaching it to the oil filter port (Figure 20). Install the new oil filter (P/N 603 00 00-41) onto the engine oil
filter port. See following NOTE.
NOTE: Use only Husqvarna oil filters designed for your engine.
6. Tighten the oil filter by hand 2/3 turn after gasket contact. Do not use a band wrench or channel lock pliers.
212
Figure 21 Add Engine Oil
Page 36 HUV 5420 DX
R
Homologated Diesel Vehicle for Europe Owner’s Manual