Hotpoint WT540 - Manual (Page 13)

13
W
ash Labels Explained
Contents
Description
Pr
ogrammes and Option Modifier
s
T
roub
leshooting
Saf
ety
Ad
vice
T
e
c
hnical
Details
Ser
vice
GB
The programme takes a
long time.
Steam is coming from the
dispenser drawer
There is too much foam?
The detergent dispenser
will not close properly or is
collecting water?
Not all the detergent has
been flushed away?
The display shows: ‘door’
Aquarius+ only
:
The display shows: ‘F000’
Aquarius+ only
:
●
Check for low water pressure.
●
Programme times listed in the Programme Table are approximate.
Options selected can affect the programme times (
see Programmes and
Option Modifiers ).
●
This is not a fault, we have designed the machine to release steam from
the dispenser drawer during hot washes.
●
The detergent is not suitable for machine washing:
If you have used the wrong type of detergent, select a Rinse programme
to flush out your machine.
●
You used too much detergent ( see Detergent and Laundry ):
Refer to the manufacturer’s recommendations.
●
Check the drawer is properly aligned.
●
Clean the dispenser drawer ( see Care and Maintenance ).
●
Check the cold water supply tap is turned on fully.
●
Check the water inlet hoses are not kinked.
●
The water pressure is insufficient.
●
The door is not fully closed, please close fully to start cycle.
●
Where 000 is the number (please contact Hotpoint Service and quote the
number).
Problem: Possible causes / Solution:
Troubleshooting