Hunter Fan Type 3 - Manual (Page 10)

10
41874-01 • 08/13/09 • Hunter Fan Company
WARNING: Use only the light fixture supplied with this fan model.
7-1. To attach the upper light kit assembly, partially install two #6-32 x
3/8” housing assembly screws into the switch housing mounting
plate.
7-2. Feed the upper plug connector through the center opening of the
assembly.
7-3. Align the keyhole slots in the assembly with the housing assembly
screws.
7-4. Turn the assembly counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8” screw into the housing. Tighten
all three screws firmly.
CAUTION: Make sure the upper light kit assembly is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the switch
housing and light fixture falling.
7-5. To attach the light kit, connect the upper plug connector from the
motor to the lower plug connector in the light kit.
Note: Both plug connectors are polarized and will only fit together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
7-6. Place the light kit fitter inside the upper light kit assembly. Align
the side screw holes. Attach the fitter to the upper assembly with
two #6-32 x 3/8” assembly screws.
Housing
Assembly
Screw
Housing
Assembly Screw
Upper
Light Kit
Assembly
Steps 7-1 – 7-3
Steps 7-5 – 7-6
Plug
Connector
Detail
Fitter
7 • Installing the Light Kit
Note: In compliance with US federal energy regulations,
this ceiling fan contains a device that restricts the
light kit to a maximum of 190 Watts. Exceeding that
limit or the marked limit on this product may result
in fire hazard or improper operation.