Harbor Freight Tools CENTRAL HYDRAULICS 36468 - Manual (Page 3)

SKUs 36468 & 36469 Page 3
9. Use eye and ear protection. Always wear ANSI approved impact safety goggles when installing
or using this product.
10. Keep children away. Children must never be allowed in the work area.
11. Do not overreach. Keep proper footing and balance at all times. Do not reach over or
across the Jack during use.
12. Never leave the product unattended while supporting an object.
13. Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are removed
from the tool or machine work surface before operating.
14. Never place your hands or other body parts near a hydraulic fluid leak. Never check for a
leak with your hands or other body parts. High-pressure fluid can be forced under your skin
resulting in serious injury.
15. Always make certain that the Hydraulic Jack and the product it is used with are set on a
flat, level and secure surface that is capable of supporting the combined weight of the
Hydraulic Jack, accompanying accessories and the weight of any material that is moved or
lifted. Make certain that the Jack is undamaged and mounted securely before use.
16. Read and adhere to the entire owner’s manual of any product that is used with the Hydraulic
Jack.
17. Always use the Jack within its rated weight load capacity, listed on the specifications table.
18. The Jack is designed for lifting only. Always use stationary supports after object is lifted.
Avoid using the Jack on slanted surfaces. Loading should be centered on the ram perpendicular
to the base.
19. Never put any part of your body under any object supported by the Jack at any time.
20. Not to be used for aircraft purposes.
Warning: The warnings, cautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood by the operator
that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
Assembly/Operation
NEVER operate the Jack with low or no hydraulic oil
(see section on “Adding Hydraulic Oil”, page 4).
Your Long Ram Flat Bottom Hydraulic Jack will require complete
assembly and installation prior to use. It is important that you read the entire
manual to become familiar with the product BEFORE you assemble and use
the Hydraulic Jack. Before assembling and operating the Hydraulic Jack be
sure that you have all parts described in the Parts List and Assembly Diagram
located on the last pages of this manual.
1. Attach the Hydraulic Jack to the product you are using. Secure the Valve
Block (1) to the product by carefully following the manufacturer’s instructions
for doing so. Do not use this Jack on a product that it is not designed
for or without being properly mounted to a product. Slide a pin (not
included) through the product and Ram (6) (See Mounting Hole, right),
securing it as well. Make sure the pin’s diameter is a push fit with just
enough clearance so that it can move freely. The pin should be held in
place with appropriate e-clips or hardened cotter pins (neither one included).
Ram (6)
Mounting
Hole
Mounting
Points
Valve
Block (1)
NEVER use
this product
without it be-
ing properly
and securely
mounted first.