Programming the remote – Harman-Kardon AVR 300 User Manual
Page 29
29 PROGRAMMING THE REMOTE
Programming the Remote
the remote for Volume Punch-Through, follow
these steps:
1. Press the Input or Video Device Selector
c
for the unit you wish to have associ-
ated with the volume control and the Mute
button
at the same time until the red light
illuminates under the Device Selector.
2. Press the Volume Up button .
3. Press either the AVR
b or the TV Device
Control Selector
, depending on which
system’s volume control you wish to have
attached for the punch-through mode. Note
that the red light under the Device Control
Selector
will blink twice and then go out
to confirm the data entry.
Example: To have the AVR’s volume control
activated even though the remote is set to
control the TV, first press the TV Device
Control Selector
and the Mute button
at the same time. Next, press the
Volume Up button
, followed by the
AVR Device Control Selector b.
NOTE: Should you wish to return the remote to
the original configuration after entering a Volume
Punch-Through, you will need to repeat the steps
shown above. However, press the same Device
Control Selector in steps one and three.
Reassigning Device-Control
Selectors
Although any of the Input or Video Device
Selectors
c
is normally assigned to the
category of product shown on the remote, it is
possible to reassign one of these buttons to oper-
ate a second device of another type. For example,
if you have two VCRs but no cable box receiver,
you may program the CBL button
to operate
a second VCR. Before following the normal pro-
gramming steps for either Three-Digit entry or Auto
Search code entry, you must first reassign the
button with the following steps:
1. Press the Input or Video Device Selector
c
you wish to reassign and the Mute
button
at the same time until the red
light illuminates under the Device Control
Selector
.
2. Press the Input or Video Device Selector
c
for the function you wish to
program into the reassigned button.
3. Enter the three-digit code for the specific
model you wish the reassigned button to
operate.
4. Press the same Input or Video Device
Selector
c
pressed in Step 1 once
again to store the selection.
Example: To use the CBL button to operate a
second VCR, first press the CBL Device
Control Selector
and the Mute button
at the same time until the red light glows
under the CBL button. Press the VCR button,
followed by the three-digit code for the specific
model you wish to control. Finally, press the
CBL button again.
31
35
35
35
35
31
35
35
35
32
31
35
35
35
32
31
35
21
25
29
30
26
22
1
5
6
7
8
9
10
11
2
3
4
12
33
31
27
23
34
32
28
24
35
36
37
38
39
40
41
42
43
44
45
46
50
51
52
53
54
55
56
47
48
49
14
18
20
13
19
15
16
17
AVR 300