Honeywell TS34C - Manual (Page 5)

5
Battery installation
• Remove the screws from the battery compartment with a small Phillips
screwdriver.
• Set the channel 1 through 5. The switch is located in the battery
compartment. Channel 1 is typically selected if only one remote
thermo-hygrometer is being used.
• Install 2 “AA” size alkaline batteries (not included) matching the polarities
shown in the battery compartment.
• Replace the battery compartment door and secure the screws.
• Secure the remote thermo-hygrometer in the desired location.
Mounting
• The remote thermo-hygrometer can be placed on the flat surface or mounted on
the wall in vertical position
• Use the wall mount hardware and screws provided when mounting the remote
thermo-hygrometer on the wall
Placement tips:
• The remote thermo-hygrometer should be placed in the area with a free air
circulation and sheltered from the direct sunlight and an extreme weather
conditions.
• Ideally, place the remote thermo-hygrometer above the natural surfaces (such as
a grassy lawn).
• Avoid placing the remote thermo-hygrometer near sources of heat such as
chimneys and heating elements.
• Avoid any areas collecting and radiating a heat from the sun, such as metal,
brick or concrete structures, paving, patios and decks.
• The international standard for the valid air temperature measurements is 4 feet
(1.25meters) above the ground.
Note: To display the readings from the remote thermo-hygrometer you must own the
main display unit of the Honeywell Professional Weather Station TE923W, model
number TE923WD. Additionally it will work with all other Honeywell weather station
models.
Troubleshooting
Q: “The remote sensor display shows dashes “---”
A: Press RESET opening with a paper clip or similar tool.
If this does not work, check the batteries and replace them.
Q: “Main unit display in temperature and humidity portion shows dashes “---“