Harbor Freight Tools 66783 - Manual (Page 6)

Page 6 For technical questions, please call 1-800-444-3353. SKU 66783
connect clip to the carburetor, fuel lines, or sheet-metal body parts. Connect to a
heavy gauge metal part of the frame or engine block.
When disconnecting charger disconnect AC cord, remove clip from vehicle
g.
chassis, and then remove clip from battery terminal.
See operating instructions for length of charge information.
h.
Follow these steps when battery is outside vehicle. A spark near battery may cause 16.
battery explosion. To reduce risk of a spark near battery:
Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a.
larger diameter than NEGATIVE (NEG, N, -) post.
Attach at least a 24 inch long 6 gauge (AWG) insulated battery cable to
b.
NEGATIVE (NEG, N, -) battery post.
Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery.
c.
Position yourself and free end of cable as far away from battery as possible- then d.
connect NEGATIVE (BLACK) charger clip to free end of the cable.
Do not face battery when making final connection.
e.
When disconnecting charger, always do so in the reverse sequence of connecting f.
procedure and break first connection while as far away from the battery as
practical.
A marine (boat) battery must be removed and charged on shore. To charge it on
g.
board requires equipment specially designed for marine use.
saVe these instruCtiOns
Specific Safety Rules for the Battery Charger
Maintain labels and nameplates on the Battery Charger. These carry important 1.
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement.
2. Always wear safety impact eye goggles and heavy work gloves when
using the Battery Charger. Using personal safety devices reduce the
risk for injury. Safety impact eye goggles and heavy work gloves are
available from Harbor Freight Tools.
Maintain a safe working environment. Keep the work area well lit. Make sure 3.
there is adequate surrounding workspace. Always keep the work area free of
obstructions, grease, oil, trash, and other debris. Do not use a power tool in areas
near flammable chemicals, dusts, and vapors. Do not use this product in a damp
or wet location.
Avoid unintentional starting. Make sure you are prepared to begin work before
4.
turning on the Battery Charger.