Holux M-1200 - Manual (Page 2)

Instructions for First Use
1. Charge the Battery
2. Switch on the Power
3. Bluetooth Link
Note about Bluetooth connection
When you power on the
M-1200 , you need to wait 6 seconds for Bluetooth to conduct
self-test before a connection is established. Wait until the Bluetooth light starts to flash (at 3
seconds interval). Then a Bluetooth link can be established between a PDA and the
M-1200 .
z Connect the supplied power cord to the mini USB
socket, and attach to car cigarette lighter.
z You can also use common USB-Mini USB cable to
charge by link M-1200 to laptop. This common USB
cable is for battery charging only, which can not
provide any data transmission function.
z Always ensure that you have inserted the end of the
power cord into the correct socket when connecting
the mini USB connector.
z Slide the power switch to the ON position.
z To operate link with a PDA (Personal Digital
Assistant): Setup the Bluetooth Manager, select
Search, and link.
z Select the HOLUX_ M-1200 device and choose SPP
slave to establish the Bluetooth link.
z Refer to the “Software Installation” section for details if
you have any problem installing the Bluetooth link.