Harbor Freight Tools 65410 - Manual (Page 7)

SKU 65410 For technical questions, please call 1-800-444-3353. Page 7
sPeciFicaTions
Electrical Requirements 120 V~ / 60 Hz / 14 A
Air Hose Connection
1/4” 18 NPT
Maximum Air Pressure 115 PSI
Air Tank Capacity 5 Gallons
Air Flow Capacity
5 SCFM @ 90 PSI
7.8 SCFM @ 40 PSI
Oil Tank Capacity 1/2 Quart
Oil Type
30W Non-Detergent
Compressor Oil
Sound Level 98 dB @ 3’
Motor 2 HP
unPacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
insTrucTions For
PuTTing inTo use
read the enTire imPorTanT
saFeTY inFormaTion
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
To PreVenT
serious injurY
From accidenTal
oPeraTion:
Turn the Power switch of the
tool to its “oFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
Thread the Air Filter (44) onto the 1.
Cylinder Head (45), as shown below.
connect air
Filter (44)
here
air connection
(47)
2. Connect a 1/4” NPT air hose (rated
165 PSI or higher) to the air connec-
tion (47). The air hose must be long
enough to reach the work area with
enough extra length to allow free
movement while working.
Incorporate an in-line oiler, shut-off
3.
valve, regulator with pressure gauge,
and filter for best service, as shown in
the diagram below. An in-line shutoff
valve is an important safety device
because it controls the air supply
even if the air hose is ruptured.