Hitachi 27CX21B - Manual (Page 18)

USING THE REMOTE TO CONTROL VCR FUNCTIONS 18
You can also use the RECALL button to quickly clear many of the other On-Screen Display.
USING THE REMOTE TO CONTROL VCR FUNCTIONS
A detailed explanation of the circled numbers follows on pages 28.
Remote Control Illustration
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the
remote system of your VCR. (Refer to page 31.)
1. Turn on your VCR.
2. Aim the remote control at the front of your VCR.
3. Press the VCR button to switch to the VCR precoded mode.
4. While holding down the VCR button on the remote, enter the two digit preset code that matches your VCR as
shown on page 31. The remote will turn off your VCR when the correct two digit preset code is entered. When this
occurs, the remote control is programmed for your VCR. If the VCR does not turn off after 5 seconds, try a
different two digit preset code.
5. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, your VCR code has not been precoded
into the remote.
2. In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult
your VCR operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure stated above.
4. If your VCR does not have a power function, the remote will issue the CHANNEL UP (
) function.
1 VCR Button
This allows the remote to control your VCR by setting it to VCR mode.
2 PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press the RECORD button
twice to record a program.
3 EXCLUSIVE TV Buttons
These buttons are for operating the TV.
NOTE: 1. Refer to the instruction manual of the VCR for operation of the buttons exclusively for the VCR.
USING THE REMOTE TO CONTROL CABLE/SATELLITE BOX FUNCTIONS
Remote Control Illustration
Operating the precoded function for your cable/satellite box.
This remote is designed to operate different types of cable boxes and digital satellite systems. You must first
program the remote to match the remote system in your cable/satellite box.