Harbor Freight Tools 96618 - Manual (Page 3)

Page 3 96618 / 96619 For technical questions, please call 1-800-444-3353.
SET uP INSTruCTIONS
read All of the SPECIFIC SAFETy rulES on the previous page,
including all text under subheadings therein before set up or use of this
product.
risk of electric shock! Do not use near water or in damp
conditions. The switch mechanism is not insulated.
Only use with grounded 120V outlet. Do not use with tool
rated higher than 120VAC, 15A.
Please note: the following setup instructions apply to both
the 96618 2-Step Foot Switch and the 96619 Foot Switch.
Make sure the tool used with the Foot Switch (router, scroll saw, wood carving
tool, for example) is in the OFF position, disconnected.
Place the Foot Switch in a location that it will be easy to reach during use.
CAuTION! The Foot Switch is intended for temporary hands-free use only and
not in place of a permanent ON/OFF power switch for the tool.
Mounting holes are available on either end of the Foot Switch base. This will
keep the Foot Switch in place and prevent any kind of accidental kicking or
movement.
If mounting, make sure the installation surface is free of any hidden wires or
cables.
If needed, the Foot Switch can be placed on the work table and used by hand.
CAuTION! Hand-use should only be done if neither foot can reach or control
the Foot Switch during use. Do not use your hand to control the foot switch if
both hands are required to operate tool.
Once the Foot Switch is placed in the proper location in the work area (under the
work table or near your chair) that can be reached by your foot (or hand), plug
the cord of Foot Switch into a grounded 120V outlet.
Plug the power cord into the 3-prong outlet located at the end of the Foot
Switch.
The Foot Switch is now ready to be used as the tool’s ON/OFF Switch.
1.
2.
3.
4.
5.
6.
7.
WArNING WArNING
WArNING for the 96618 Foot Switch! In case of a blown fuse or tripped breaker
switch when foot switch is in use, please turn off the foot switch prior to replacing the
fuse or resetting the breaker. Unplugging the tool from the foot switch is preferable.
This will help insure that the tool does not power on unexpectedly after replacing the
fuse.
07h