Switch and key, Work piece and work area set up – Harbor Freight Tools 32650 User Manual
Page 17
Page 17
For technical questions, please call 1-800-444-3353.
SKU 32650
Slide along channel
in this direction
Hold workpiece
against face of gauge
Table Top (7) channel
Miter Gauge
Assembly (1)
Figure 24
To use the Gauge:
Loosen the Miter Knob (1d) counter
1.
clockwise and rotate the Miter Scale (1a)
so the Miter Indicator (1b) is pointing
to the desired degree on the Indicator.
Tighten in place with the Miter Knob.
Place the Miter Bar (1c) in the channel
2.
on the Table Top (7) and hold the work
piece against the face of the gauge.
Slide the Assembly along the channel to
3.
make the cut.
Switch and key
The ON/OFF Switch (27a) is located on
the front of the machine. On is up and
off is down. The Switch Key (27b) is a
safety feature and must be in the Switch
(27a) for the Shaper/Router to function.
The Switch Key (27b) can be removed
when the switch is in the off position only.
Make sure the machine is unplugged
before removing the Switch Key.
Figure 25
Remove Switch Key (27b)
to Lock Shaper/Router
Switch Key (27b) in
Switch (27a)
To lock the Shaper/Router when not in
use, unplug the Shaper/Router and pull
out the Switch Key.
Work Piece and Work area Set up
Designate a work area that is clean and
1.
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
Secure loose work pieces using a vise
3.
or clamps (not included) to prevent
movement while working.
There must not be objects, such as utility
4.
lines, nearby that will present a hazard
while working.
When working with stock that does
5.
not receive sufficient support from the
machine’s table, use a table extension.
Fence extensions can also be added
the Fence Assembly (2), attaching them
through the holes on the Fence faces.
reV 10e