Hotpoint WMA63 - Manual (Page 14)

When you are using
the pre-wash option
with your selected
programme add
detergent to the
pre-wash
compartment
(l symbol).
Add the detergent
for the main wash
to the main
compartment
(ll symbol).
Dispensing
liquid detergent
The liquid
retaining flap is
preset for adding
powder detergent.
To add liquid
detergent, change
the position of the
liquid retaining
flap as follows.
Pull the liquid
retaining flap
towards you. 1 Push this flap
down until it is
secure. 2
The liquid detergent retaining flap indicates four lines
which represent the amount of liquid you may need to
use (see 2 above). Do not go above the maximum level of
200ml.
Note: It is normal when using liquid detergent, for a small
amount of water to remain in this compartment, after the
wash has finished. Lift the flap slightly and it will drain
away.
Using in-drum
dosing Pre-wash
Dispensing tablets
Dispensing powder detergent
To achieve the best wash results the
manufacturer’s recommended amount
of detergent should be measured and
added to the dispenser drawer (max.
400ml).
Adding fabric
conditioner
Pour the
recommended
dosage of fabric
conditioner into
the compartment
(flower symbol).
Do not exceed the
maximum fill line.
14
WARNING:
● Do not put any
item(s) into
the drawer
other than
detergents
that are
designed to be
released from
the drawer as
they may cause
damage or
blockage.
Most tablets are dispensed via the machine drum using a net,
or similar device, which is placed on top of the washload
towards the back of the drum. However, some tablets are
designed to be placed in the dispenser drawer. Check the
pack for details.
Dosing devices -
balls, nets etc can
be used. Place
upright, on top of
the wash load and
towards the back
of the machine.
Do not use with
the pre-wash
option.
THE
DISPENSER
ULTIMA BOOK 1666200010-02 04/07/2001 4:01 pm Page 14