Harbor Freight Tools Pacifichydrostar 68333 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. SKU 68333
direction. you will have a clearer idea of the time
involved to clean the area after doing a test run.
5. Clear the cleaning area of all objects that
are not being cleaned. If any water prone or
delicate items cannot be moved, protect them. If
detergent is to be used, cover or remove any
plants or animals that may be damaged by the
detergent. Disconnect power to and protect any
nearby electrical wiring from water and spray.
6. Place the Pressure Washer in a location which is
protected from any water from the cleaning area.
Select a location higher than the cleaning area. The
pressure washer’s location should be close enough
so that the hose will reach every portion of the job to
be done with some slack for movement. Also, select
an area with proper access to a dedicated circuit.
7. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
tool Set up
tO PREvEnt SERiOuS injuRy FROm
aCCiDEntal OPERatiOn:
turn the Power Switch of the pressure washer
off, unplug it from its electrical outlet, and
relieve all pressure in a safe manner before
making adjustments or installing accessories.
1. MAKE SURE THE WASHER IS CLEAN AND READy
FOR USE. Ensure the inlet water strainer, nozzle,
and the rest of the Washer are completely free of
buildup or debris.
Attach the Extension Nozzle by inserting
it into the end of the gun then rotating it
clockwise until it clicks into place.
2. If using the Soap Dispenser:
a. Remove the dispenser lid and fill with pressure
washer detergent (sold separately).
b. Set the spray to the fan setting by turning the
end of the Extension Nozzle counterclockwise.
c. Insert the Extension Nozzle into the large end
of the Dispenser cap, pressing until it clicks into
place.
3. Before connecting the water supply, run
water through the garden hose (sold
separately) to remove any debris.
4. Turn off the water, then thread the garden
hose onto the Water Supply Inlet on
the back of the Pressure Washer.
5.
Reset Button
Test Button
Plug the power cord into a power outlet and test
the GFCI by pressing the Reset and Test buttons
as described in Controls and Features section.