beautypg.com

Personalisations, Setting the temperature, Functions – Hotpoint HVL 241 User Manual

Page 9

background image

9

G B

Function

Effect

Comments

Enabled with

programmes:

Super

Wash

Allows for an

impeccable wash,

visibly whiter

than a standard

Class A wash.

This function is incompatible with the QUICK WASH function.

A, B, C, D,

E, F, G, H

Easy Iron

This option

reduces the

amount of

creasing on

fabrics, making

them easier to

iron.

When this function is set, programmes F, G, H ,K, L, N will end

with the laundry left to soak (Anti-crease) and the Rinse cycle

phase LED will flash.

- to conclude the cycle, press the START button;

- to run the draining cycle alone, set the knob to the relative

programme (R) and press the START button.

All

programmes

except for

A, B, J, R

Quick

Wash

Cuts the

duration of the

wash cycle by

30%.

This function is incompatible with the SUPER WASH function.

A, B, C, D,

E, F, G, H

Extra

Rinse

Increases the

efficiency of

the rinse.

Recommended when the appliance has a full load or with large

quantities of detergent.

A, B, C, D, E,

F, G, H, M, N

Personalisations

Setting the temperature

Turn the VARIABLE TEMPERATURE knob to set the wash temperature (see Programme table on page 8).

The temperature can be lowered, or even set to a cold wash (Cold).

Functions

To enable a function:

1. press the button corresponding to the desired function, according to the table below;

2. the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the

programme set.

Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner

by continuously rotating the drum at a speed which is slightly faster than the normal washing speed.

When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed

than the set frequency.

If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.

The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.