Hustler Turf 927558 - Manual (Page 21)

WARNING: The ROPS structure’s protective capability
may be impaired by structural damage, overturn or
alteration. Do not remove or alter any of the ROPS parts.
Do not attempt to weld or straighten ROPS. Failure to adhere
to these instructions could result in severe injury or death.
Driving the tractor
DANGER: Never make sudden stops or reverse direction,
especially when maneuvering on a slope. The steering is
designed for sensitive response. Rapid movement of the
control levers in either direction could result in a reaction of
the tractor that can cause serious injury.
After starting engine, engage the control levers and steer as follows:
To go forward, push control levers forward an equal distance (Fig. 3-
14).
To go in reverse, pull control levers rearward an equal distance (Fig. 3-
14).
To turn left, move the right control lever farther forward from neutral
than the left control lever.(Fig. 3-14)
To turn right, move the left control lever farther forward from neutral
than the right control lever. (Fig. 3-14)
“0” degree turn, move one control lever forward and the other control
lever back of neutral. This will allow the drive wheels to counter-rotate.
(Fig. 3-14)
To stop or decrease speed, move control levers to neutral. When going
forward pull back gently on control levers. When going in reverse push
forward gently on control levers.
For emergency stop, when traveling forward or rearward, place the
steering control levers in the park brake position immediately.
DANGER: When moving in the rearward direction push
forward gently on steering control levers and avoid sudden
movement. Any sudden movement could cause the front of
the mower to come off of the ground resulting in possible
loss of control, causing serious injury or death.
To make a three point turn to the right, move the left control lever
farther forward from neutral than the right control lever and start the turn.
Next, pull back on the control levers until they are past neutral and the
machine starts to go rearward. Pull right control lever farther rearward
from neutral than the left control lever until the rear of the machine has
pivoted around. Then, push the control levers forward until they are both
past neutral and the machine starts to go forward. Push the left control
lever farther forward from neutral than the right control lever and finish the
turn. (Fig. 3-15)
IMPORTANT: Rapid movement of control levers is not recommended
as damage to the hydraulic system components may occur.
To increase speed, increase control lever’s distance from neutral. The
farther forward control levers are from neutral, the faster tractor will travel
forward. The farther back control levers are from neutral, the faster tractor
will go in reverse.
Operating suggestions
DANGER: Prior to operating the tractor the operator should
be thoroughly familiar with the proper use and operation of
the equipment, should read the manual completely and
thoroughly, and should have attempted slow moving
maneuvers to become familiar with the operation of the
equipment before attempting normal speed operation. An
inexperienced operator should not mow on slopes or on
uneven terrain.
WARNING: If you lose steering control while operating
the machine, place the steering control levers in the park
brake position immediately. Inspect the machine and
involve your Hustler dealer to resolve the problem before
continuing to operate.
WARNING: The unit’s steering control levers are very
responsive: Easy does it! For smooth operation, move lever
slowly, avoid sudden movement. Skill and ease of operation
come with practice and experience. The machine can spin
very rapidly. Use caution when making turns and slow down
before making sharp turns.
Inexperienced operators may have a tendency to oversteer and lose
control. Slow-moving practice maneuvers are recommended to become
familiar with these characteristics before attempting normal speed
operation.
WARNING: Sharp depressions or raised obstacles (such as
gutters or curbs) should not be directly approached at high
speed in an attempt to “jump” them as the operator could be
thrown from the equipment. Approach at a slow speed and
angle one drive wheel at the obstruction. Continue at an
angle until the wheel clears and then pivot the opposite wheel
around.
When turning on soft wet turf, keep both wheels rolling either forward
or backward. Pivoting on one stopped wheel can damage turf. This is
especially important when mowing.
Tractor performance is maximum when the throttle is set at full rpm.
This gives maximum power to the drive wheels and deck when needed.
FRONT OF TRACTOR FACES THIS DIRECTION
Figure 3-14
FORWARD TRAVEL ZERO DEGREE TURN REVERSE TRAVEL
RIGHT TURN
REVERSE TRAVEL
N N
FORWARD TRAVEL
RIGHT TURN
N = Neutral Position
Direction of arrows indicate direction of tractor movement.
601656_1108 20